Best Way to Cut Vinyl Fence

The vinyl fences currently in use are becoming more and more common. You can try installing a vinyl fence at home. In fact, its installation is very simple. If you can succeed, you will have a very beautiful fence and a sense of accomplishment. So let's take a look at the specific steps to install a vinyl fence.

Do the following：

What is vinyl fencing

When i need cut vinyl fence 

Best way to cut vinyl fence

Definition of vinyl fencing

Vinyl fence is a plastic fence made of polyvinyl chloride (PVC). PVC resin is a combination of special ingredients that make vinyl fences, exceptional impact strength, durability and weather ability.

Vinyl is a simple alternative to other barrier materials. Vinyl fences do not warp, rot, crack or blisters like wooden fences, nor do they rust, chip, peel or corrode like aluminum. Vinyl does not need to be sanded, dyed or painted. Surface dirt and debris are easily cleaned by regularly spraying water from the garden hose.

Plastic fences are a safe choice for families and pet owners. Unlike wood fences, which are usually chemically treated to protect the fence from weathering, vinyl is non-toxic. It does not split, has no nails or sharp edges that can harm children or animals. Plastic is also an environmentally friendly barrier material because it is fully recyclable and offers an ecologically conscious alternative to reduce the wood fence supply of trees.

When i need cut vinyl fence

1.What you will need

• Tape measuring

• Chalk line

• Circular saw

• Saw blade with fine teeth

• 2-by-4s

• Sander

• Sandpaper

• Duct tape

2.Precautions

This is not a difficult job, but it does take time and attention to do this without damaging the vinyl fence.

Best way to cut vinyl fence

Step 1 - Measure the vinyl fencing

Go to your yard location, where you plan to install the vinyl fence and use the measuring tape to determine the height you want the fence. Remember, when you install a vinyl fence, you must place the column deeper than the wood or metal pile. This extra depth must be calculated before measuring the fence. Use the measurements and transfer them to the fence pieces using the chalk line so you can easily decipher the lines to be cut. Leave half an inch more as part of the railway hanger.

Step 2 - Set up the cut and leave signs

Vinyl fences are usually hollow, making it difficult to cut when using a circular saw, regardless of the teeth on the blade. When the teeth bite into the vinyl, they shake and vibrate. This can lead to cracking and cracking of the ethylene. To prevent this from happening, you must remain stable. Place the first piece to be cut on the work area. With it in the right place, then you can install a 2 by 4 vinyl sheet on each side of the sandwich. This will put the vinyl sheet in place.

Step 3 - Make the cut

Even if the vinyl sheets are in place and safe, they can still be chopped and torn apart. Align the chalk with the guide. Make sure your hand is not close to the blade and then open it. Once the blade reaches full speed, it gradually decreases to vinyl. Put your hand on the vinyl to make sure it (away from the blade) and let the blade do the work as it is lowered to the vinyl. Do not rush to cut, but keep the blade moving so that it does not damage the vinyl. Continue in this way until you are completely done with the thing you are doing. Continue cutting through the vinyl fence pieces until they are all cut and ready to install.

Step 4 - Finish up

Be careful when installing the vinyl fence, which has been cut, because even the slightest crack can cause the fence to be destroyed. Use the tape to wrap the bottom pieces on the ground and gently sand the edges.

Always observe safety procedures when cutting and installing vinyl fencing or guardrail products. When you cut, small pieces of vinyl may fly into your eyes, causing damage or obstructing your view. Wear safety glasses and protective clothing, including work gloves, to protect yourself. Then follow the steps above and it is very easy to cut vinyl fencing.