Can you cut vinyl fence panels?

The only disadvantage of vinyl fence panels is their poor stiffness. Therefore, in the assembly structure, the lining steel is added as a reinforcing rib in the plastic structural member according to the wind load requirement to make up for the deficiency. The vinyl fence panel does not require paint and maintenance, and the old and new are not old, eliminating the fatigue and trouble of maintenance. Easy to manufacture and install, it is installed with patented squeegee connection or proprietary connection accessories, which greatly improves installation efficiency. The vinyl fence panel has a wide variety of specifications, a variety of shapes, European and American styles and today's fashion, which can show the noble and modern beauty.

Content list of this article：

—  You can cut

—  Steps for cutting

—  Precautions

Principle of cutting 

The aqueous solution of the salt is chemically decomposed by the action of the current. This process produces chlorine, caustic soda and hydrogen. Refined, cracked petroleum or gasoline can produce ethylene. When chlorine and ethylene are mixed, dichloroethylene is produced; and dichloroethylene can be converted to produce a vinyl chloride, which is an essential component of polyvinyl chloride. Therefore the vinyl fence panels can be cut.

Steps for cutting

When cutting with a saw blade.

1. Preparation tools: hook knife, pen, knife, bamboo stick, cardboard

2. Then measure the size with a bamboo pole or ruler and mark with a pen.

3. After aligning and fixing, use a hook knife to start a shallow scratch. Don't use too much force at first to avoid mistakes.

4. The paper jam must be fixed by hand. The hook knife gently draws a mark to ensure that the scratch is straight and then slowly deepens.

5. When pulling the hook knife, it is best to finish it, of course, more labor-saving than using a saw blade

When cutting with an angle grinder.

1. The practical tape measure accurately measures the length of the cut.

2. Use a marker to mark the side of the vinyl fence panel away from the cut-free. Make a few more tokens and connect the tokens you made with the lines.

3. Secure it with a tool that secures the fence so that it can obtain a vertical cut surface.

4. While fixing the fence board with something, cut it with the angle grinder according to the line drawn by the marker.

5. Use an angle grinder to properly smooth the protruding parts that are not well treated during cutting.

6. Sand the area where glue is needed and wipe the polished area with a rag.

What are the precautions?

1. Be sure to measure the accuracy when making the mark, try to add a few marks as much as possible, and then connect the marks with a pen.

2. When cutting with a saw blade, do not use too much force when starting the scratch with a hook knife to avoid mistakes.

3. Make sure the scratches are straight and then slowly deepen.

4. Be sure to fix the vinyl fence panel when it is fixed, so as not to cause problems when loosening during cutting.

5. Because the angle grinder will be uneven when it is cut, it is necessary to smooth the convex part.

6. It is not recommended to use laser cutting to cut non-metallic plates such as vinyl fence panels. Laser cutting of non-metals can easily cause deformation of non-metallic materials and be melted.

The vinyl fence panel is very safe, and it also meets the environmental protection advocated by the world today. It is harmless to people (livestock). Even if it is not intended to touch the guardrail, it will not hurt people like steel and iron guardrails. The vinyl fence panel does not fade, does not yellow, does not peel, does not crack, does not blister, does not worm, and has a service life of more than 30 years.