How to attach lattice to a vinyl fence

Vinyl fences don't need to be painted and maintained, they are old and new, eliminating the fatigue and hassle of your maintenance, and the overall cost is low. The vinyl fence is easy to install and install, and it is installed with a patented squeegee connection or a proprietary connection accessory, which greatly improves the installation efficiency. It has a wide variety of specifications, safe and environmentally friendly ingredients, no harm to people and animals, even if it is not intended to touch the guardrail, it will not hurt like steel and iron guardrails. The vinyl fence is made of special formula and special UV absorber, no fading, no yellowing, no peeling, no cracking, no blistering, no insects, and the service life can reach more than 30 years.

This is the content table of the article：

1. Preparation list

2. Way to attach

3. Precautions

Preparation list 

Instructions for filling out the form must be available. Because it explicitly requires that the vinyl fence grid installation list and any content in its pricing formula should not be arbitrarily deleted or altered. Explain the installation overview. It is necessary to state the construction scale of the vinyl fence, the characteristics of the fence, the conditions of the construction site, and the natural geography. All places requiring signature and seal must be signed and sealed by the prescribed units and personnel. The number of valid digits should be in accordance with the regulations. The items of the measures should be as comprehensive as possible.

Way to attach 

① Construction procedure: fixed door post, corner column and middle column → unfolding braided net → fixed starting end → fixed tensioner fixed → clamping weft thread tensioning → tying fixed net piece → moving to the next net segment construction.

② From the end of the middle column, lay the braided net along the fence line. The braided net is laid on the inner side of the fenced grassland, and the grid is tightly oriented toward the column, and the starting end is left with a 5m~~8m braided net.

③ Raise the braided net and tie each weft end to the starting intermediate column.

Precautions

1.  The spacing between the column and the steel lining must be the same as the design size to ensure that the pre-assembled semi-finished products can be connected to it.

2.  Pull the upper and lower parallel lines in the straight line to make the installation adjustment standard to ensure the straightness of the upper and lower ends after the vinyl fence is installed.

3.  After the reinforcement parts of the vinyl fences are in place, only the vinyl fence beams and the columns need to be connected and fixed during on-site construction.

4.  If the vinyl fence beam beam needs to be pre-buried, firstly determine the pre-buried point according to the drawing, find the level, and then use the holes opener. The diameter of the hole puncher is about 60mm~83mm, the depth is 50mm, and the embedded beam is 30~50mm.

5.  After the vinyl fence piece enters the base hole, adjust the horizontal level of the beam, tilt, and twist the hole.

6.  Re-check the installation effect and adjust it again if it is not vertical or non-parallel.

7． Clean the surface of the vinyl fence.

Vinyl fence net is an important safety isolation measure. As important equipment, we must pay great attention to the installation details of the vinyl fence net during the installation process to ensure the installation of the vinyl fence net is in place. Before the construction of the vinyl fence net, the fence rails should be pre-buried for re-inspection. For the missing, leaking and misplaced fence boards, measures should be taken to rectify the position before the construction can begin.