How to avoid tree roots when constructing a fence?

The steps to install a vinyl fence are very simple, but if you encounter a root, it's not the same. Tree roots can be a daunting task. You need to change the location of the semi-private vinyl fence installation or remove the root of the big tree. But when neither of them works, a simple viewing bar would be a good choice. After all, cutting the roots is definitely unhealthy for trees and in some cases may cause trees to die. When encountering such problems, be sure to have sufficient preparations to resolve them. Invasive or aggressive root growth reduces the structural and aesthetic integrity of the fence because its columns cannot align or cause the fence to bend. So how do we avoid roots?

Article list:

—  Required tools

—  Solution steps

—  Suggest

Required tools

Work gloves, Safety glasses, Shovel, Landscape bar, Chainsaw

Solution steps

Measure the length of the fence line.

Place the pile on the length of the proposed vinyl fence line. Then string a string between each pile to show the route the fence moves. Piles should be driven into the ground at the end of each fence pile.

Consider the distance between the existing trees and the proposed fence line.

Measure the distance between the proposed vinyl fence line and the nearby trees. The studs and fence posts will eventually replace them and should be outside the range of the drip line or any branch extension. Large and small roots usually only extend to branches. By placing the fence post outside the fence line, you can minimize the possibility of problems.

Locate existing tree roots by mining.

Gently excavate on each pile to determine any roots near the pile in the future. If you build a vinyl fence in the drip line, you may need to change the position of the column by moving the column a few inches or moving the column a few inches down to avoid damaging any large roots. If the fence is too close to nearby trees or other plants, you may not be able to push the column through the existing roots.

Knock the stakes down.

Knock the pile to a depth of 2 to 3 feet in areas where the column is not allowed to be installed. Professional vinyl fence installers recommend drilling or excavating 3 1/2 foot holes for any column that requires a concrete foundation to prevent pests and increase stability.

Reposition the plan hole.

Relocate the predetermined hole in the area where the obstacle is encountered. This may require minimizing or increasing the spacing between the holes. However, if you can move or tilt the vinyl fence properly and cross the entire length of the fence, you can maintain the column regularly.

Suggest

When you arrange vinyl fences, try to avoid areas that may contain roots. Before starting your project, use a metal tube probe (similar to a large hail device) to detect the roots on the ground along the path of the fence.

Take extra care when operating the chain saw, especially in confined areas such as holes.

Cutting off the roots of a big tree can cause it to die or cause disease. The roots will regenerate after a few years, depending on the species, but additional watering is required during this time.

If you are worried about damage to trees, consult a tree scientist before cutting any roots.

How to avoid the root installation of the vinyl fence? I hope this article will help you. If you want to install a vinyl fence, you can contact us if you have any questions.