What can't be done by installing a vinyl ranch fence？

How to install the vinyl ranch fence I believe everyone knows, although it is very simple, but still make some mistakes. Sometimes small mistakes can have big consequences. After all, the vinyl fence is not so cheap, and if it is destroyed, it will be a heavy loss. Then let's talk about the mistakes that are often made when installing vinyl fences and how to prevent them from making mistakes.

We may make mistakes:

Error 1: No fence panel squares set

Error 2: The door is not properly installed

Error 3: Did not dig deep enough back hole

Error 4: Do not consider tilting or grading the ground

Error 1: No fence panel squares set

All homeowners must be hoping that their fence will follow their own property line, and the hotel is the same. But if you don't have a vinyl fence panel square, then it's hard to get the fence to follow the property line. It's not that simple to set the fence panels to each other's squares. There are many ways to ensure that your fence posts and panels are placed at a 90 degree angle, but the easiest way is to use only two tape measures and some simple math. This method is commonly referred to as the 3-4-5 triangle method.

Error 2: The door is not properly installed

Many people often forget the door when installing a vinyl ranch fence, but the door is really important, especially for the ranch fence. The gate needs to be planned and measured at the beginning of construction. After all, it is not free to enter and exit.

To properly install the door, you need to make sure that the spacing around it is close without obstructing it. You also need to make sure that your door does not scratch the ground when it is open, but it does not leave much space underneath it when it is closed. If your door is level, leave a gap of about 1 inch below the bottom of the door and below the floor. If your ground is not flat, make sure the gate is installed above the highest point and swings towards the lower end of the slope. The last thing you want is the door that hits the ground when you turn it on or off.

Error 3: Did not dig deep enough back hole

Although the vinyl fence is more durable than the wooden fence, it still needs to be placed deep in the ground to avoid tilting later. The best way to ensure that your borehole is deep enough is to rent an auger with a 10" auger bit and dig into a 3 foot mark.

Error 4: Do not consider tilting or grading the ground

It can't be careless, and tilting can cause big problems. When encountering a sloping ground, you need to plan ahead to make sure the vinyl fence looks good and functioning properly. In the vinyl fence installation process, there are two commonly used methods for handling inclined ground: stepping and folding.

When you are installing a vinyl ranch fence, be sure to avoid these problems, just in case something is wrong, it is not a cheap thing. Of course, you should also be aware that you must not want to do it yourself. Vinyl fence installation is the best job for two or more people, especially when it comes to hanging panels and doors from fence posts. If you still have questions, please feel free to ask us, we will have someone to answer your questions.